Setup secondary optic box without default router

[BryceWilkinson]

Hi there,

I have a setup where I’m using a ubiquiti edge router and igmp-proxy forward etc without issue. One of the optic boxes fried and was sent a new one. I can’t move past the setup screen asking to sync wirelessly with default Telus router. I’m not in a position to take down our network and reset up the original router just to move past the screen. It’s hardwired into the network. Is there a key combo or something to skip this window.

[xray]

When I switched from wireless to Ethernet on my Optik boxes I just plugged in the Ethernet cable and it connected. I think it should skip the WiFi setup if it gets an IP address off the Ethernet interface. Are you getting a link light on the Ethernet port?

What is your LAN subnet? I wonder if the Optik box is expecting a 192.168.1.xxxx address from DHCP.

[BryceWilkinson]

Hi there,

I have a link light and an IP address.

The subnet 10.50.0.0/23

[BryceWilkinson]

https://ibb.co/JvjzCBj

Now stuck on client initialization and failing